SPI emulator with Intel (Calpella) Red Fort CRB

ZC2580(8M), ZC2564(64M) SPI Memory Emulators Discussions

SPI emulator with Intel (Calpella) Red Fort CRB

Postby info » Mon Aug 10, 2009 2:19 pm

why replace circuit solution would not work on Intel (Calpella) Red Fort CRB,
As both of serial flash chips on Red Fort CRB are Atmel's AT26DF321
Image
Checking Atmel's AT26DF321 Datasheet (page2 to page3)
you can find out it's Hold Pin in NC
that's why there is no way to use "voltage divider principle" on hold pin to
disable on baord SPI flash part and replace with emulator
(that's why even test clip with replace function will not work on it)
the only way is desodering AT26DF321
Image
after desoldering, you can see the footprint with SO8W and SO16 dual layout
so just soldering 1.27mm pitch 2*4 pin head on CRB and then you can connect emulator easily.
Image
As everyone would prefer like to preserve CRB in origin status,
may need to double check with own design board in the future.
in fact, it's really inconvenient to desolder and soder serial flash chip back to to test and verify.
If so, you can try this accessory--SDW0016AA
SPI S016 socket to 1.27mm 2x4 female head
after desodering, put the unmounted AT26DF321 in to SO16 socket
Image
Image
Image
Image
connecting the SDW0016AA on CRB, you can use a real serial flash chip to tesk and verify.
Image
after removing it you can connecting SPI flash emulator conveniently.
Image
To support 2 serial flash chip you will need two SDW0016AA
Image
When SPI flash emlator emulates 1 serial flash chip, the red extend line will be "reset" function, please do not connect to this pin.
Image
If firmware upgrade to emulate 2 serial flash chip function(share same SPI bus)
then the function of red extend line will change from "reset" to "CS2" and then you can connect to CS2 PIN on CRB.
Image
Easily to meet your development reqirement with emulating 1 or 2 flash chips with one emulator.
And it is really convenient for your working on frequently test and verify.
Finally if you need to return CRB back to INTEL, just desoldering pin head
and soldering serial flash chip back will be OK.
(from beginning to end you just need to desoder and solder for twice)
with SDW0016AA, to test on other vender's serial flash chip will be easy than ever.
Just putting different vendor's serial flash chip in to socket and connect to pin head on CRB to test and verify directly.
User avatar
info
 
Posts: 12
Joined: Sat Dec 18, 2010 5:56 pm

Return to ZC25 Series Emulators

Who is online

Users browsing this forum: No registered users and 1 guest

replica watches 1:1 best edition replica watches 高仿手表